1350, 1410, 1480 and 1550 series kits with 6061-T6 aluminum tubing — everything you need to build a lighter, stronger, vibration-free driveshaft. Free shipping on every kit.
Measure the bearing cap of your current U-joint or send us a photo of your yoke. We'll tell you the series and the right kit — free.
Measure the bearing cap diameter and the lock-up (cap to cap) of your current U-joint. Match it to the table — or send us a photo.
| Series | Bearing cap Ø | Lock-up / yoke width | Typical use | Kit |
|---|
Measure the bearing cap diameter with a caliper (1.188" or 1.375").
Measure cap to cap across the U-joint (3.625", 4.188" or 4.969").
Measure your shaft center-to-center of the U-joints with the suspension loaded, and pick the tube length that covers it.
A 6061-T6 aluminum tube in the listed length and diameter, matched aluminum weld yokes for the series, and the specs you need to cut and weld it to length. U-joints, slip yokes and flange yokes are sold separately or added when we build it for you.
Yes. Order the kit and choose "Build it for me" at checkout, or bring your measurements to the shop in Medley. We cut, weld, phase and balance at high RPM, then ship or hand it over same day in most cases.
Kits ship from Miami within 1–2 business days via UPS/FedEx Ground; 2–5 days in the continental US. Free shipping on every kit. Local pickup in Medley is always available.
Aluminum is lighter, resists corrosion and has a higher critical speed for long shafts — ideal for trucks, SUVs, Jeeps and street/strip cars. For extreme torque or commercial duty we also fabricate steel shafts to order.
Send us a photo of your yoke before ordering and we'll confirm the series for free. Unused kits in original condition can be exchanged within 30 days.